Confirm Current Setting

WARNING: This page is about a different car, the 2019 Subaru Ascent. However, it is still accessible from the selected car via links, so may be relevant.

On [Start] screen, select [Diagnosis].
On [Vehicle selection] screen, input the target vehicle information and select [OK].
On [Main Menu] screen, select [Each System].
On [Select System] screen, select [Body Control], and then select [Enter].
On [Select Function] screen, select [Customize].

Save the setting.

REQUIRED ITEMS FOR NEW REGISTRATION. (EXCEPT FOR SYSTEM NOT EQUIPPED)

Item	Item to confirm				Remarks
Off delay time	OFF	10 Sec	20 Sec	30s	-
Auto Light Sensitivity Adjustment	Dull	Normal	Sensitive	Very sensitive	-
Lane change signal setting	Exist		Not Exist		-
Rear wiper auto setting	Exist		Not Exist		-
Driver's Door Unlock Setting	ALL		Selection		-
Rear Gate Unlock Setting	ALL		Selection		-
Wiper link Auto Light Setup	ON		OFF		-
High Beam Assist Function Setting (mirror/EyeSight)	Not Exist mirror HBA EyeSight HBA				-
Head Lamp Low Beam Specification	Halogen HIDLED				-
Head Lamp High Beam Specification	Halogen HIDLED				-
High Beam Assist Current Setting	ON		OFF		-
Rr Defogger op. mode	Normal		Continuous		-
Security Alarm Setup	ON		OFF		-
Alarm delay setup	ON		OFF		-
Lockout prevention	ON		OFF		-
Answer-back buzzer setup	ON		OFF		-
Hazard answer-back setup	ON		OFF		-
Door open warning	Exist		Not Exist		-
Dome Light Alarm Setting	ON		OFF		-
Auto A/C Setting	Exist		Not Exist		-
wiperdeicer	Exist		Not Exist		-
Steering Wheel	Left		Right		-
Remote Trunk Open/Power Rear Gate Open Function (ON/OFF)	OFF				-
HBA ON/OFF setting	ON		OFF		-
Illumination Sensor Setting	Exist		Not Exist		-
Factory initial setting	Factory		Market		Do not change to factory mode.
Welcome Light Off Delay Time (Approaching)	OFF 30 seconds 60 seconds 90 seconds				-
Welcome Lighting (Exiting)	OFF 30 seconds 60 seconds 90 seconds				-
Keyless Buzzer Volume	1 2 3 4 5 6 7				-
Auto Dimmer Cancel Setting	0 (OFF) Least Less Normal More Most				-