Drive Plate: Installation

WARNING: This page is about a different car, the 2019 Subaru Ascent. However, it is still accessible from the selected car via links, so may be relevant.

Temporarily install the drive plate and reinforcement drive plate.
Set the ST in the position shown in the figure.
Preparation tool:

ST: CRANKSHAFT STOPPER (498497300)

Courtesy of SUBARU OF AMERICA, INC.

Tighten the drive plate mounting bolt in two stages.

NOTE: Fix the engine unit.

Tighten the drive plate mounting bolt.
Tightening torque:

30 N.m (3.1 kgf-m, 22.1 ft-lb)

While checking the tightening angle with the angle gauge, tighten the drive plate mounting bolts to the specified angle.

Tightening angle:

30° - 35°

Courtesy of SUBARU OF AMERICA, INC.

Install the transmission body. Ref. to CONTINUOUSLY VARIABLE TRANSMISSION (TR690)>TRANSMISSION ASSEMBLY>INSTALLATION .