LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2019 >> Ascent Base >> Repair and Diagnosis >> Suspension >> Wheel Alignment >> Front Suspension System And Wheel Alignment >> Front Arm >> Assembly >> Rubber Bushing Arm Front Rear

Rubber Bushing Arm Front Rear

  1. Before installation, inspect the following items and replace any faulty part with a new one.
    • Check the arm assembly front for damage or cracks, and replace if defective.
    • Visually check the bushing for abnormal cracks, fatigue or damage.
    • Visually check the boot on the ball joint COMPL for damage.
  2. Install the rubber bushing arm front rear to the arm assembly front.
    CAUTION: Confirm the installing direction and install securely.
    1. Install the spacer arm (a) and the stopper rubber arm (b).
      G13199332Courtesy of SUBARU OF AMERICA, INC.
    2. Install the rubber bushing arm front rear so that protrusion (a) faces the rear side of the vehicle.
      G13199333Courtesy of SUBARU OF AMERICA, INC.
    3. Install the stopper rubber arm (c) and the plate arm front (d).
      G13199334Courtesy of SUBARU OF AMERICA, INC.
    4. Using new self-locking nuts, install the rubber bushing arm front rear to the arm assembly front by matching the alignment marks that have been marked when removing.

      Tightening torque: 

      140 N.m (14.3 kgf-m, 103.3 ft-lb)

      • Arm assembly front replacement: align the cutout portion of the arm assembly front with the alignment mark (a) of the rubber bushing arm front rear.
        G13199328Courtesy of SUBARU OF AMERICA, INC.
      • Rubber bushing arm front rear replacement: align the alignment mark (b) on the arm assembly front with the imaginary line extending from the rib portion of the rubber bushing arm front rear.
        G13199329Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals