Rear Combination Light Assembly: Inspection
- Apply battery voltage between the connector terminals to check the lighting condition of the light.
Terminal No. Inspection conditions Specification 5 (+) - 6 (-) Apply battery voltage. Stop light on 1 (+) - 6 (-) Tail/side marker light on 2 (+) - 6 (-) Turn signal light on 3 (+) - 6 (-) Back-up light on - Replace the harness and bulb if it is found defective.
NOTE:
Since LED (Light Emitting Diode) is used for the tail light and stop light, replace the lens and body COMPL if the light does not illuminate.