Water Pump: Installation
WARNING: This page is about a different variant/trim than selected.
- Install the water pump onto cylinder block LH.NOTE:
- Use a new gasket.
- When installing the water pump, tighten the bolts in two stages in alphabetical sequence as shown in figure.
Tightening Torque:
First:
12 N.m (1.2 kgf-m, 8.9 ft-lb)
Second:
12 N.m (1.2 kgf-m, 8.9 ft-lb)
- Install the hose to water pump.
- Install the tensioner bracket.
Tightening Torque:
24.5 N.m (2.5 kgf-m, 18.1 ft-lb)
- Install the belt cover No. 2 LH.
Tightening Torque:
5 N.m (0.5 kgf-m, 3.7 ft-lb)
- Install the cam sprocket LH. Ref. to MECHANICAL (STI)>Cam Sprocket>INSTALLATION .
- Install the belt idler No. 2 (C).
Tightening Torque:
39 N.m (4.0 kgf-m, 28.8 ft-lb)
- Install the belt idler (B).
Tightening Torque:
25 N.m (2.5 kgf-m, 18.4 ft-lb)
- Install the automatic belt tension adjuster (A) with the tension rod held by a pin. Ref. to MECHANICAL (STI)>Timing Belt>INSTALLATION>AUTOMATIC BELT TENSION ADJUSTER ASSEMBLY AND BELT IDLER
.
- Install the timing belt. Ref. to MECHANICAL (STI)>Timing Belt>INSTALLATION>TIMING BELT .
- Install the timing belt cover. Ref. to MECHANICAL (STI)>Timing Belt Cover>INSTALLATION .
- Install the crank pulley. Ref. to MECHANICAL (STI)>Crank Pulley>INSTALLATION .
- Install the V-belts. Ref. to MECHANICAL (STI)>V-belt>INSTALLATION .
- Install the radiator. Ref. to COOLING(STI)>Radiator>INSTALLATION .