LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2018 >> WRX Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 44 (Emission Control Systems (Aux. Emission Control Devices)) >> Leak Check Valve Assembly >> Installation

Leak Check Valve Assembly: Installation

WARNING: This page is about a different car, the 2022 Subaru WRX. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the leak check valve assembly bracket.

    Tightening torque: 

    8 N.m (0.8 kgf-m, 5.9 ft-lb)

  2. Connect the drain tube to the leak check valve assembly. Ref. to FUEL INJECTION (FUEL SYSTEMS) (H4DOTC)>FUEL DELIVERY AND EVAPORATION LINES>INSTALLATION>QUICK CONNECTOR CONNECTION (TYPE G)
  3. Install the leak check valve assembly.

    Tightening torque: 

    8 N.m (0.8 kgf-m, 5.9 ft-lb)

  4. Connect the connector (E).
  5. Install the circulate tube (D) to the clip (C).
  6. Connect drain tube (A) and drain tube (B). Ref. to FUEL INJECTION (FUEL SYSTEMS) (H4DOTC)>FUEL DELIVERY AND EVAPORATION LINES>INSTALLATION>QUICK CONNECTOR CONNECTION (TYPE G)
    G13224170Courtesy of SUBARU OF AMERICA, INC.
  7. Lower the vehicle.
  8. Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY
scientia non olet · About LEMON Manuals