Crank Pulley: Removal

WARNING: This page is about a different car, the 2022 Subaru WRX. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

When replacing a single part, perform the work with the engine assembly installed to body.

When working on the vehicle
NOTE:
When working on the vehicle, perform the following steps also.
1. Remove the air intake duct. Ref. to INTAKE (INDUCTION) (H4DOTC)>AIR INTAKE DUCT>REMOVAL
Remove the V-belts. Ref. to MECHANICAL (H4DOTC)>V-BELT>REMOVAL>V-BELT
Use the ST1 and ST2 to lock the crank pulley, remove the crank pulley bolt.
NOTE:
To prevent damaging ST1, attach the ST2 onto the ST1 as shown in the figure.

Courtesy of SUBARU OF AMERICA, INC.

Preparation tool:

ST1: PULLEY WRENCH (18355AA000)

ST2: PULLEY WRENCH PIN SET (18334AA000)

Courtesy of SUBARU OF AMERICA, INC.
Remove the crank pulley.
Remove the front oil seal from the chain cover.

Courtesy of SUBARU OF AMERICA, INC.