LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2018 >> WRX Base >> Repair and Diagnosis >> Brakes >> Traction Control >> Vehicle Dynamics Control System >> Brake Lamp Relay >> Operation >> Brake Light Lighting Operation Mode By SUBARU Select Monitor

Brake Light Lighting Operation Mode By SUBARU Select Monitor

CAUTION: For models with Eye-Sight, performing brake light relay compulsory operation may cause the Eye-Sight warning light to illuminate. If the brake light relay compulsory operation is performed, refer to "Basic Diagnostic Procedure" of "Eye-Sight (DIAGNOSTICS)" and check DTCs and then clear memory. Ref. to Eye-Sight (DIAGNOSTICS)>Basic Diagnostic Procedure .
  1. Connect the Subaru Select Monitor.
    NOTE:
    • In the event of any trouble, brake light lighting operation mode will not function.
    • For detailed operation procedures, refer to "Application Help".
    1. On «Start» display, select «Diagnosis».
    2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».
    3. On «Main Menu» display, select «Each System».
    4. On «Select System» display, select «Brake Control System» and select «Enter».
    5. On «Select Function» display, select «Work Support».
    6. From the work support item list, select «Brake Lamp Lighting Operation» mode.
  2. Operate according to the procedures displayed in the Subaru Select Monitor.
scientia non olet · About LEMON Manuals