Fender Panel
CAUTION:
- Install the bumper face - front so that the front end of the under cover (b) comes inside the bumper face - front (a), and the front end of the mud guard (c) comes outside the bumper face - front (a).
- Before installing the bumper face, match the claws on the bracket - front bumper with the engaging position of flange section on the bumper face side. If the engaging position is not correct, the flange section may be broken or the clearance between fender panel and bumper face may not be uniform.
- Install the fender COMPL - front.
Tightening Torque:
7.5 N.m (0.8 kgf-m, 5.5 ft-lb)
NOTE: When installing the fender COMPL - front, make sure that a uniform clearance is created around it.- Fender COMPL - front to Hood COMPL - front: Ref. to EXTERIOR BODY PANELS>Front Hood>ADJUSTMENT
- Fender COMPL - front to Panel assembly - front door: Ref. to EXTERIOR BODY PANELS>Front Door>ADJUSTMENT
- Install the cover - A pillar assembly.
- Install the garnish assembly - fender. Ref. to EXTERIOR BODY PANELS>Front Fender>INSTALLATION>FENDER GARNISH
- Install the spoiler assembly - side. Ref. to EXTERIOR/INTERIOR TRIM>Side Garnish & Side Spoiler>INSTALLATION
- Install the mud guard - front.
- Install the light assembly - head.
Tightening Torque:
7.5 N.m (0.8 kgf-m, 5.5 ft-lb)
- Install the bumper face - front. Ref. to EXTERIOR/INTERIOR TRIM>Front Bumper>INSTALLATION
- Connect the battery ground terminal. Ref. to NOTE>NOTE>BATTERY
- Adjust the headlight beam and fog light beam.
- Adjust the headlight beam. Ref. to LIGHTING SYSTEM>Headlight Assembly>ADJUSTMENT>HEADLIGHT BEAM ADJUSTMENT
- Adjust the fog light beam. (Model with fog light) Ref. to LIGHTING SYSTEM>Front Fog Light Assembly>ADJUSTMENT>FOG LIGHT AIMING