DTC P0192: Fuel Rail Pressure Sensor Circuit Low Bank 1: Notes

DTC detecting condition:

Immediately at fault recognition

Trouble symptom:

Improper idling
Poor driving performance

CAUTION:

After servicing or replacing faulty parts, perform Clear Memory Mode Ref. to ENGINE (DIAGNOSTICS) (EXCEPT FOR STI)>Clear Memory Mode>OPERATION , and inspection mode Ref. to ENGINE (DIAGNOSTICS) (EXCEPT FOR STI)>Inspection Mode>PROCEDURE .

Use the check board when measuring the ECM terminal voltage and resistance.

Wiring diagram:

Engine Electrical System Ref. to WIRING SYSTEM>Engine Electrical System>WIRING DIAGRAM .

G09480917

Courtesy of SUBARU OF AMERICA, INC.

CHECK HARNESS BETWEEN ECM AND FUEL PRESSURE SENSOR CONNECTOR .
1. Turn the ignition switch to OFF.
2. Disconnect the connector from ECM.
3. Disconnect the connector from the fuel pressure sensor.
4. Measure the resistance between the ECM connector and engine ground.
  Connector & terminal
  
  (E158) No. 6 - Engine ground:
Is the resistance 1 MΩ or more?

Yes: Replace the fuel pressure sensor. Ref. to FUEL INJECTION (FUEL SYSTEMS) (EXCEPT FOR STI)>Fuel Pressure Sensor .

No: Repair the ground short circuit of harness between ECM connector and fuel pressure sensor connector.