LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2018 >> WRX Base >> Repair and Diagnosis (Single Page) >> Body & Frame >> Door Locks >> Anti-Theft System - Security And Locks (Service Information) >> Keyless Entry Control Module >> Removal

Keyless Entry Control Module: Removal

  1. Disconnect the ground cable from battery and wait for at least 60 seconds before starting work. Ref. to NOTE>NOTE>BATTERY
    NOTE: For model with battery sensor, disconnect the ground terminal from battery sensor.
  2. Remove the trim panel assembly - rear shelf. Ref. to EXTERIOR/INTERIOR TRIM>Rear Shelf Trim>REMOVAL
  3. Remove the keyless entry control module.
    1. Disconnect the connector.
    2. Remove the bolt and then remove the keyless entry control module.
      NOTE: For models with power amplifier, installation position of the keyless entry control module is different.
      G12457034Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals