Basic Diagnostic Procedure: Procedure

CAUTION:

Subaru Select Monitor kit is required for reading DTC, performing diagnosis and reading current data.
Before removal or installation, be sure to remove any foreign matter (dust, moisture, oil, etc.).
Registration of immobilizer may be needed after the replacement of control modules, etc. For detailed procedure, refer to the "REGISTRATION MANUAL FOR IMMOBILIZER" provided as a separate volume. Contact an Authorized Subaru Dealership.

NOTE:

Using the Function Setting (Customize), check that the keyless access system is not in a cancelled state. Ref. to SECURITY AND LOCKS>Function Setting (Customize)>OPERATION
Check List for Interview Ref. to KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS)>Check List for Interview

CHECK BATTERY .
Use a tester to measure the voltage of the battery.

Is the voltage 11 V or more?

Yes: Go to 2

No: Charge or replace the battery and perform check pre-inspection. Go to 2
CHECK PRE-INSPECTION .
Use the interview check list to interview the user. Ref. to KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS)>Check List for Interview

Was the symptoms of the trouble recorded in the interview?

Yes: Go to 3

No: Interview the user again.
BASIC INSPECTION .
Perform the inspection for LAN system. Ref. to LAN SYSTEM (DIAGNOSTICS)>Basic Diagnostic Procedure>PROCEDURE

Is the check result OK?

Yes: Go to 4

No: Check it according to DTC of LAN system. Ref. to LAN SYSTEM (DIAGNOSTICS)>Basic Diagnostic Procedure>PROCEDURE
CHECK TROUBLE SYMPTOM .
1. Read DTCs for the keyless access system. Ref. to KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS)>Read Diagnostic Trouble Code (DTC)>OPERATION
  NOTE: If the communication function of the Subaru Select Monitor cannot be executed properly, check the communication circuit. Ref. to KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS)>Subaru Select Monitor>COMMUNICATION FOR INITIALIZING IMPOSSIBLE
2. Record all DTCs, time stamp and freeze frame data.
  NOTE: For time stamp, refer to "LAN SYSTEM". Ref. to LAN SYSTEM (DIAGNOSTICS)>General Description>CAUTION>TIME STAMP
Are any DTCs displayed?

Yes: Perform the diagnosis for the displayed DTCs. After diagnosis, Go to 7

No: Go to 5
CHECK PHENOMENON LIST .
Check the "Phenomenon List". Ref. to KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS)>General Diagnostic Table

Is there a symptom that corresponds in the phenomenon list?

Yes: Perform diagnosis according to the procedures in the phenomenon list.

No: Go to 6
CHECK TROUBLE PHENOMENON .
1. Perform check of current data. Ref. to KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS)>Read Current Data
2. Perform a function check. Ref. to KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS)>General Description>CAUTION>KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM
3. Perform a unit check.
Was the trouble cause found?

Yes: Repair the cause of trouble.

No: Repeat a basic check again.
PERFORM DIAGNOSIS .
1. Perform the Clear Memory Mode. Ref. to KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS)>Clear Memory Mode
2. Perform the Inspection Mode. Ref. to KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS)>Inspection Mode
Are any DTCs displayed?

Yes: Perform the diagnosis for the displayed DTCs.

No: Finish the diagnosis.