LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2018 >> Outback 2.5i >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 14 (CVT Transaxle (Tr690)) >> Transfer Clutch >> Installation

Transfer Clutch: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Apply CVTF to the seal ring and attach it to the seal ring groove of transfer clutch assembly.
    NOTE:
    • Use new seal rings.
    • When installing the seal rings, do not expand the seal rings too much.
    G06654512Courtesy of SUBARU OF AMERICA, INC.
  2. Install the transfer clutch assembly.
    G06654511Courtesy of SUBARU OF AMERICA, INC.
  3. Select the thrust needle bearing. Ref. to CONTINUOUSLY VARIABLE TRANSMISSION(TR690)>Rear Drive Shaft>ADJUSTMENT .
  4. Install the selected thrust needle bearing and needle bearing to transfer clutch assembly.
    NOTE: Install the thrust needle bearing in the correct direction.
    G06654499Courtesy of SUBARU OF AMERICA, INC.
  5. Install the rear drive shaft. Ref. to CONTINUOUSLY VARIABLE TRANSMISSION(TR690)>Rear Drive Shaft>INSTALLATION .
  6. Install the extension case. Ref. to CONTINUOUSLY VARIABLE TRANSMISSION(TR690)>Extension Case>INSTALLATION .
  7. Install the transmission assembly to the vehicle. Ref. to CONTINUOUSLY VARIABLE TRANSMISSION(TR690)>Automatic Transmission Assembly>INSTALLATION .
scientia non olet · About LEMON Manuals