LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2018 >> Outback 2.5i >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Power Rear Gate System >> Power Rear Gate Drive Unit >> Removal

Power Rear Gate Drive Unit: Removal

  1. Disconnect the ground terminal from the battery sensor, and wait for at least 60 seconds before starting work. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
  2. Remove the rod - power rear gate. Ref. to POWER REAR GATE SYSTEM>Power Rear Gate Rod>REMOVAL .
  3. Remove the trim panel - rear apron LH and trim panel - rear quarter pillar UPR rear LH PRG. Ref. to EXTERIOR/INTERIOR TRIM>Rear Quarter Trim>REMOVAL .
  4. Remove the power rear gate drive unit (PRG D/U).
    1. Remove the harness clip, and disconnect the connector.
      NOTE: Pull the slide lock in the arrowed direction, and disconnect the PRG CONTROL MODULE connector by pressing in the lock.
      G10309973Courtesy of SUBARU OF AMERICA, INC.
    2. Remove the bolts, and then remove the power rear gate drive unit (PRG D/U).
    G10309974Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals