Entertainment System: Camera: Inspection: Rear

Park the vehicle at a level place where there are enough area at the rear of the vehicle.
Attach the tape as the target point for standard at the floor rearward of the vehicle as shown in the figure below.
NOTE: Standard tape width is about 30 - 50 mm (1.18 - 1.97 in) and brilliant color shall be used.

Courtesy of SUBARU OF AMERICA, INC.
Confirm the following before checking the corresponding items.
1. Rearview camera image is not displayed. (Camera screen alone is not displayed normally)
  1. Check the reverse signal using {Vehicle Signal} in Line Diag mode. Ref. to ENTERTAINMENT & MONITORING>Audio System>OPERATION>CHECK VEHICLE SIGNALS WITH LINE DIAG MODE .
  2. Check the connecting condition of the rearview camera using {Connection} in Line Diag mode. Ref. to ENTERTAINMENT & MONITORING>Audio System>OPERATION>CHECK CONNECTIONS WITH LINE DIAG MODE .
2. Guide line cannot be displayed or the position of the guide line is wrong.
  The rearview camera may be defective, or its installation location on the vehicle may be deformed. Check the rearview camera and its installation location on the vehicle, and repair or replace if necessary.