VDC Control Module Parameter Reading

WARNING: This page is about a different car, the 2018 Subaru Crosstrek. However, it is still accessible from the selected car via links, so may be relevant.

Perform reading of parameter.
1. Connect the Subaru Select Monitor.
  NOTE: For detailed operation procedures, refer to "Application help".
2. Turn the ignition switch to ON.
3. On [Start] display, select [Diagnosis].
4. On [Select Vehicle] display, input the target vehicle information and select [Set].
5. On [Main Menu] display, select [Each System].
6. On [Select System] display, select [Brake Control], and then select [Enter].
7. On [Select Function] display, select [Work Support].
8. On [Work Support] display, select [Reading of parameter: ECM to SSM].
Save and close the file.