Keyless Access Control Module: Removal

1. Disconnect the ground cable from battery. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
2. Remove the pocket assembly and the back panel - pocket. Ref. to EXTERIOR/INTERIOR TRIM>Glove Box>REMOVAL .
3. Remove the keyless access control module.

CAUTION: Be careful to keep water and other foreign materials away from body integrated unit terminals.

1. Disconnect the connector.
2. Release the claws using a flat tip screwdriver or similar tool wrapped with protection tape.
3. Release the guides, and pull out the keyless access Control Module as shown in the figure.

Fig 1: Removing Keyless Access Control Module Claws Using Flat Tip Screwdriver Or Similar Tool Wrapped With Protection Tape

Courtesy of SUBARU OF AMERICA, INC.