Knock Sensor: Installation

WARNING: This page is about a different car, the 2018 Subaru Crosstrek. However, it is still accessible from the selected car via links, so may be relevant.

Install the knock sensor to the cylinder block, and connect the connector to the knock sensor.
NOTE:
- Knock sensor must be positioned so that the connector center comes within the range shown in the figure.
- Make sure that the knock sensor and its connector do not touch the adjacent parts.
Tightening torque:

25 N.m (2.5kgf-m, 18.4ft-lb)

Courtesy of SUBARU OF AMERICA, INC.
Install the air intake boot. Ref. to INTAKE (INDUCTION) (H4DO)>Air Intake Boot>INSTALLATION .
Connect the battery ground terminal. Ref. to REPAIR CONTENTS>NOTE>BATTERY .