Active Test: Operation
CAUTION:
After executing the system operation check mode, clear the memory Ref. to ENGINE (DIAGNOSTICS) (H4DO)>Clear Memory Mode>OPERATION .
NOTE:
For operation procedures, refer to the "Help for Subaru Select Monitor".
- On [Start] display, select [Diagnosis].
- On [Vehicle selection] display, enter vehicle information and select [OK].
- On [Main Menu] display, select [Each System].
- On [Select System] display, select [Engine Control System] and select [Enter].
- On [Select Function] display, select [Active Test].
| Active test items | Contents | Execution condition | ||
|---|---|---|---|---|
| [Fuel Pump Relay] | ON/OFF of the fuel pump can be set. | Ignition switch ON (engine OFF) | ||
| CPC Solenoid Valve | ON/OFF of the purge control solenoid valve can be set. | |||
| Radiator Fan Relay | ON/OFF of the radiator fan relay can be set. | |||
| A/C Compressor Relay | ON/OFF of the A/C relay can be set. | |||
| ELCM switching valve | ON/OFF of the leak check valve assembly switching valve can be set. | |||
| ELCM pump | ON/OFF of the leak check valve assembly vacuum pump can be set. | |||
| Fuel Pump Control (OFF Drive) | Fuel pump can be set to OFF. | Idling | ||
| Fixed Idle Ignition Timing | Idle ignition timing can be set and fixed to 10°. | Idling | ||
| Idle Speed Control | Idle speed can be set to 500 - 2000 rpm. | Idling | ||
| Injection Stop Mode (Injector 1) Injection Stop Mode (Injector 2) Injection Stop Mode (Injector 3) Injection Stop Mode (Injector 4) |
Injector of each cylinder can be set to stop the fuel injection. | Idling | ||
| Injection Quantity Control | The amount of fuel injection can be set to 0 - 20%. | Idling | ||
| EGR Valve Control (Step) | EGR control valve can be set to 0 - 255 STEP. | Idling | ||
| Alternator control | Alternator control mode can be set to one of the followings: Low mode Middle mode High mode ExHigh mode(1) |
Idling | ||
| Compression monitor | Compression can be measured. |
|
||
|
||||