LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2018 >> Forester 2.5i, Standard Trans >> Repair and Diagnosis >> Accessories & Equipment >> Communication Devices >> Body Control System (Diagnostics) >> Customize >> Operation

Body Control System (Diagnostics): Customize: Operation

  1. On [Start] display, select [Diagnosis].
  2. On [Vehicle selection] display, input the target vehicle information and select [OK].
  3. On [Main Menu] display, select [Each System].
  4. On [Select System] display, select [Body Control], and then select [Enter].
  5. On [Select Function] display, select [Customize].
    NOTE:
    • If not equipped (depending on destination area or vehicle equipment condition), customizing is not possible.
    • For detailed operation procedures, refer to "Application help".

    List of User Customizing item

    Data Initial setting value Customize setting Remarks
    Off delay time 30s OFF Room light off delay time can be selected.
    10 Sec
    20 Sec
    30s
    Auto Light Sensitivity Adjustment Normal Dull Slow response
    Normal Standard
    Sensitive Quick response
    Very sensitive Fairly quick response
    Driver's Door Unlock Setting Selection ALL The door to be unlocked when you touch the driver's door can be set.
    Selection
    Rear Gate Unlock Setting Selection ALL The door to be unlocked when you touch the rear gate switch can be set.
    Selection
    One-touch Turn Signal System Setup ON ON Workable when the "Lane change signal setting" is set to "Yes". ON/OFF of the one-touch blinker can be set.
    OFF
    Auto Wiper System (Rear) Setup ((3)) Exist Workable when the "Rear wiper auto setting" is set to "Yes".

    ON/OFF of the rear wiper linked with reverse operation can be set.


    (3): Set to "No" for U4 and U5. Set to "Yes" for C0, C4, and C5.
    Not Exist
    High Beam Assist Current Setting ((3)) ON High beam assist is activated.
    OFF High beam assist is deactivated.
    Rr Defogger op. mode ((1)) Normal Normal Automatically stops in 15 minutes after the switch is turned to ON.
    Continuous Repeats activated for 15 minutes and deactivated for 2 minutes until the switch is turned to OFF.
    Security Alarm Setup ON ON Security alarm (hazard, horn or siren) becomes activated.
    OFF Security alarm becomes deactivated.
    Impact Sensor Setup OFF ON Workable when the Impact Sensor Setup is set to "Yes". Impact sensor function becomes activated.
    OFF Impact sensor function becomes deactivated. (Be sure to set to {OFF} in models without sensors.)
    Alarm delay setup ON - After the keyless lock operation, the alarm monitor starts after the following delay time has passed.
    ON Delay time is 30 seconds.
    OFF Delay time is 0 second.
    Lockout prevention ON ON key lockout prevention function is activated. (The function does not operate if safety knob is locked by hand.)
    OFF Key lockout prevention function is deactivated.
    Impact sensor (OP) Not Exist Exist Vehicle is controlled in impact sensor equipped mode. (Make sure to set to "No" for models without the impact sensor. When set to "Yes", hazard, horn or siren become activated by keyless lock (alarm monitor start).)
    Not Exist Vehicle is controlled in impact sensor non-equipped mode.
    Answer-back buzzer setup
    ((2))    		 ON ON Buzzer operates when lock/unlock is selected by keyless entry system operation.
    OFF Buzzer does not operate when lock/unlock is selected by keyless entry system operation.
    Hazard answer-back setup ON ON Hazard blinks when lock/unlock is selected by keyless entry system operation.
    OFF Hazard is not interlocked when lock/unlock is selected by keyless entry system operation.
    Passive Alarm OFF ON -
    OFF -
    Door open warning Exist Exist If a door stays half shut for 20 minutes, interior lighting linked with the door such as room light, map light, luggage room light, trunk room light and key ring illumination go off to prevent battery run-out.
    Not Exist Room light, map light, luggage room light, trunk room light, key ring illumination and door warning light remain lit.
    Dome Light Alarm Setting OFF ON Room light illuminates interlocking with alarm.
    OFF Room light does not illuminate interlocking with alarm.
    Welcome Lighting (Exiting) 30s OFF Length of the lighting time can be set.
    30s
    60 s
    90 s
    Welcome Light Off Delay Time(Approaching) 30s OFF Length of the lighting time can be set.
    30s
    60 s
    90 s
    Keyless Buzzer Volume 5 1 through 7 Buzzer volume can be set.
    Remote control trunk open/power rear gate open function (ON/OFF) ON ON The power rear gate open function operates by pressing and holding the keyless transmitter.
    OFF The power rear gate open function does not operate by pressing and holding the keyless transmitter.
    (1) Wiper deicer operates in accordance with rear defogger operations.

    (2) Power rear gate operation start buzzer is also linked to this setting. Alert buzzers such as for pinching detection is not included.

    (3) Customization item according to the actual vehicle equipment.
  6. When the setting is complete, make sure that the alterations by [Data monitor] are consistent with the actual equipment on the vehicle.
    CAUTION:
    • the above settings must match the actual vehicle equipment.
    • Do not change settings except for setting above while setting the functions.
    • Be sure not to change Factory initial setting except when installing a new body integrated unit.
scientia non olet · About LEMON Manuals