Secondary Pressure Sensor: Installation
CAUTION:
- Be sure to prevent water or oil from contacting the connector terminal of secondary pressure sensor. If adhesion occurs, replace with a new part.
- After installing the secondary pressure sensor, adjust the CVTF level.
Install in the reverse order of removal.
NOTE:
- Use new O-rings.
- Apply CVTF to the O-rings.
Tightening torque:
Secondary pressure sensor
39 N.m (4.0 kgf-m, 28.8 ft-lb)
Under cover front - transmission
18 N.m (1.8 kgf-m, 13.3 ft-lb)