LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2018 >> Forester 2.5i Touring >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Control/Fuel Injection System (H4DOTC)) >> Throttle Body >> Removal

Throttle Body: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Remove the collector cover.
    1. Remove the clip (A).
    2. Hold the shaded area (B) by hand and carefully pull the RH side (C) upward.
    3. Hold the shaded area (D) by hand and carefully pull the LH side (E) upward.
    G12508846Courtesy of SUBARU OF AMERICA, INC.
  2. Disconnect the ground cable from battery.
  3. Lift up the vehicle.
  4. Remove the under cover. Ref. to EXTERIOR/INTERIOR TRIM>FRONT UNDER COVER>REMOVAL .
  5. Drain approximately 3.0 L (3.2 US qt, 2.6 Imp qt) of coolant. Ref. to COOLING (H4DOTC)>Engine Coolant>REPLACEMENT>DRAINING OF ENGINE COOLANT .
  6. Remove the intercooler. Ref. to INTAKE (INDUCTION) (H4DOTC)>INTERCOOLER>REMOVAL .
  7. Remove the intake duct No. 3. Ref. to INTAKE (INDUCTION) (H4DOTC)>Intake Duct>REMOVAL>INTAKE DUCT NO. 3 .
  8. Disconnect the connector (A) from the throttle position sensor, and disconnect the preheater hose (B) from the throttle body.
    G12508847Courtesy of SUBARU OF AMERICA, INC.
  9. Remove the throttle body from the intake manifold.
    G12508848Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals