LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2018 >> Forester 2.5i Premium, Standard Trans >> Repair and Diagnosis >> Accessories & Equipment >> Cruise Control Systems >> Cruise Control System >> Cruise Control Command Switch >> Installation

Cruise Control Command Switch: Installation

CAUTION:
  • Before handling the airbag system components, refer to "CAUTION" of "General Description" in "AIRBAG SYSTEM". Ref. to AIRBAG SYSTEM>General Description>CAUTION .
  • Do not allow harness and connectors to interfere or get tangled up with other parts.
  • If the steering wheel has been removed, make sure that the steering roll connector is not turned from the original position.
  • If the steering wheel and steering angle sensor (steering roll connector) are removed, perform "VSC(VDC) Centering Mode" of the VDC. Ref. to VEHICLE DYNAMICS CONTROL (VDC)>VDC Control Module and Hydraulic Control Unit (VDCCM & H/U)>ADJUSTMENT .
  • Securely install the switch. Improper insertion of the pin or claw of the switch may cause improper installation.
  1. Align the center position of the steering roll connector. Ref. to AIRBAG SYSTEM>Roll Connector>ADJUSTMENT .
  2. Install each part in the reverse order of removal.
    NOTE: Align the alignment marks on the steering wheel and the column assembly - steering.

    Tightening torque: 

    Steering wheel: 39 N.m (3.98 kgf-m, 28.8 ft-lb)

    Clearance: 

    Between cover assembly - column and steering wheel: 4 - 6 mm (0.16 - 0.24 in)

  3. Connect the battery ground terminal. Ref. to NOTE>NOTE>BATTERY .
scientia non olet · About LEMON Manuals