DTC P0604: Internal Control Module Random Access Memory (Ram) Error: Notes

DTC detecting condition:

Immediately at fault recognition

Trouble symptom:

Engine does not start.
Engine stalls.

CAUTION: After servicing or replacing faulty parts, perform Clear Memory Ref. to ENGINE (DIAGNOSTICS) (H4DOTC)>Clear Memory Mode>OPERATION . and Inspection Mode Ref. to ENGINE (DIAGNOSTICS) (H4DOTC)>Inspection Mode>PROCEDURE ..

CHECK DTC .
Using the Subaru Select Monitor or a general scan tool, read the DTC of [Engine]. Ref. to ENGINE (DIAGNOSTICS) (H4DOTC)>READ DIAGNOSTIC TROUBLE CODE (DTC) .

Is DTC other than P0604 displayed? (Current malfunction)

Yes: Check the appropriate DTC using the "List of Diagnostic Trouble Code (DTC)". Ref. to ENGINE (DIAGNOSTICS) (H4DOTC)>LIST OF DIAGNOSTIC TROUBLE CODE (DTC) .

No: Even if DTC is detected, the circuit has returned to a normal condition at this time. Reproduce the failure, and then perform the diagnosis again.

NOTE: In this case, temporary poor contact of connector, temporary open or short circuit of harness may be the cause.