LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2018 >> Crosstrek Premium, Standard Trans >> Repair and Diagnosis >> Engine Mechanical >> Engine Lubrication System >> Oil Level Switch >> Removal

Oil Level Switch: Removal

CAUTION: If the engine oil is spilt over the engine, exhaust pipe or the under cover, completely wipe it off to avoid emission of smoke or causing a fire.
  1. Remove the striker - front hood. Ref. to EXTERIOR BODY PANELS>Front Hood>DISASSEMBLY .
  2. Fully open the front hood. Ref. to REPAIR CONTENTS>NOTE>FRONT HOOD STAY .
  3. Disconnect the ground cable from battery. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
  4. Remove the V-belt covers.
    G12391348Courtesy of SUBARU OF AMERICA, INC.
  5. Remove the air intake duct. Ref. to INTAKE (INDUCTION) (H4DO)>Air Intake Duct>REMOVAL .
  6. Remove the clip from the air intake boot, and loosen the clamp.
    G11252776Courtesy of SUBARU OF AMERICA, INC.
  7. Remove the air intake boot, and place it aside so that it does not interfere with the work.
    CAUTION: Be careful not to pull out the PCV hose.
    G11252777Courtesy of SUBARU OF AMERICA, INC.
  8. Remove the TCM. (CVT model) Ref. to CONTINUOUSLY VARIABLE TRANSMISSION (TR580)>Transmission Control Module (TCM)>REMOVAL .
  9. Turn the transmission harness clockwise till the bolt hole can be seen as shown in the figure, and tighten the bolt to temporary lock the harness. (CVT model)
    G11253157Courtesy of SUBARU OF AMERICA, INC.
  10. Remove the pitching stopper. (MT model)

    6MT model: 

    Ref. to MANUAL TRANSMISSION AND DIFFERENTIAL (6MT)>Transmission Mounting System>REMOVAL>PITCHING STOPPER .

  11. Drain the engine oil. Ref. to LUBRICATION (H4DO)>Engine Oil>REPLACEMENT .
  12. Remove the front exhaust pipe. Ref. to EXHAUST (H4DO)>Front Exhaust Pipe>REMOVAL .
  13. Remove the nuts which secure the engine mounting to the crossmember. (CVT model)
    G11253160Courtesy of SUBARU OF AMERICA, INC.
  14. Remove the nuts which secure the engine mounting to the crossmember. (MT model)
    G11253161Courtesy of SUBARU OF AMERICA, INC.
  15. Remove the electric power steering gearbox. Ref. to POWER ASSISTED SYSTEM (POWER STEERING)>Electric Power Steering Gearbox>REMOVAL .
  16. Attach the ST1 and ST2.

    Preparation tool: 

    ST1: BOLT (18363AA050)

    ST2: HANGER (18360AA040)

    Tightening torque: 

    43 N.m (4.4kgf-m, 31.7ft-lb) 

    G11253302Courtesy of SUBARU OF AMERICA, INC.
  17. Lift up the engine with a lifting device and wire ropes.
    CAUTION: When lifting up the engine, pay attention to the clearance of each part and be careful not to lift the engine too much, in order to prevent damaging the vehicle.
    G08316851Courtesy of SUBARU OF AMERICA, INC.
  18. Remove the engine mounting LH.
    G11253671Courtesy of SUBARU OF AMERICA, INC.
  19. Disconnect the connector and remove the clips.
    G11253672Courtesy of SUBARU OF AMERICA, INC.
  20. Remove the clip to remove the oil level switch.
    G11253673Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals