Master Cylinder: Installation

Install the master cylinder.
Tightening torque:

18 N.m (1.8kgf-m, 13.3ft-lb)

Courtesy of SUBARU OF AMERICA, INC.
Tighten the clutch pipe.
Tightening torque:

15 N.m (1.5kgf-m, 11.1ft-lb)

Courtesy of SUBARU OF AMERICA, INC.
Install the push rod of the master cylinder, and install the clevis pin and clip.
CAUTION: Always use a new clevis pin.

NOTE: Apply grease to the clevis pin.

Courtesy of SUBARU OF AMERICA, INC.
Install the clutch pedal assembly. Ref. to CLUTCH SYSTEM>Clutch Pedal>INSTALLATION .
Install the steering column. Ref. to POWER ASSISTED SYSTEM (POWER STEERING)>Steering Column>INSTALLATION .
Add the recommended brake fluid. Ref. to CLUTCH SYSTEM>CLUTCH FLUID .
After bleeding air from the clutch system, ensure that no fluid leaks and the clutch operates properly. Ref. to CLUTCH SYSTEM>CLUTCH FLUID AIR BLEEDING .
Install the instrument panel lower cover. Ref. to EXTERIOR/INTERIOR TRIM>Instrument Panel Lower Cover>INSTALLATION .
Connect the battery ground terminal. Ref. to REPAIR CONTENTS>NOTE>BATTERY .