LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2018 >> Crosstrek Base, Standard Trans >> Repair and Diagnosis >> Suspension >> Wheel Alignment >> Rear Suspension System >> Stabilizer >> Installation >> Stabilizer Bushing

Stabilizer Bushing

  1. Before installation, inspect the following items and replace any faulty part with a new one.

    Check the bushing - stabilizer for abnormal cracks, fatigue or damage.

  2. Install the bushing - stabilizer.
  3. Install the clamp - stabilizer bushing.

    Tightening torque: 

    30 N.m (3.1kgf-m, 22.1ft-lb)

  4. Install the bracket COMPL - stabilizer.
    CAUTION: To prevent damage to the vehicle body, place a cloth, etc. between the bracket COMPL - stabilizer and the vehicle body. After tightening nuts to specified torque, be sure to remove the cloth, etc.

    Tightening torque: 

    35 N.m (3.6kgf-m, 25.8ft-lb)

  5. Install the rear wheels and lower the vehicle.

    Tightening torque: 

    120 N.m (12.2kgf-m, 88.5ft-lb)

scientia non olet · About LEMON Manuals