Common Specs & Procedures
CROSSTREK COMMON SPECIFICATIONS & PROCEDURES
| System | Specification/Procedure | |||
|---|---|---|---|---|
| Air Conditioning | ||||
| Service | SPECIFICATION | |||
| Torque | See Torque Specifications in Text and applicable graphics under COMPONENT | |||
| Axle Shaft Nut (Front) | 162 Ft. lb. (220 N.m) | |||
| Axle Shaft Nut (Rear) | 140 Ft. lb. (190 N.m) | |||
| Battery | ||||
| Except Hybrid | SPECIFICATION | |||
| Brakes | ||||
| Bleeding Sequence | RR, LR, RF, LF AIR BLEEDING |
|||
| Disc Brakes | ||||
| Front Disc Brakes | SPECIFICATION | |||
| Rear Disc Brakes | SPECIFICATION | |||
| Torque | See Torque Specifications in Text or applicable graphics under COMPONENT | |||
| Charging | ||||
| Generator | ||||
| Except Hybrid | SPECIFICATION | |||
| Torque | See Torque Specifications in Text or applicable graphics under: | |||
| Except Hybrid | COMPONENTS WITH TORQUE SPECIFICATIONS | |||
| Drive Belts | ||||
| Belt Routing & Adjustment | INSTALLATION | |||
| Engine Cooling | ||||
| General Service Specifications | SPECIFICATION | |||
| Radiator Cap Pressure | 14-18 psi (.95-1.25 kg/cm2 ) | |||
| Thermostat R & I | THERMOSTAT | |||
| Water Pump R & I | WATER PUMP | |||
| Engine Mechanical (2.0L) | ||||
| Compression | ||||
| Test Procedure | COMPRESSION | |||
| Standard | 152-203 psi (1050-1400 kPa, 11-14 kgf/cm2 ) | |||
| Difference Between Cylinders | 14 psi (100 kPa (0.5 kgf/cm2 ) or less | |||
| Oil Pressure | SPECIFICATION | |||
| At Idle Speed | 4.9 psi (34 kPa, 0.3 kg/cm2 ) Or More | |||
| At 6000 RPM | 43.2 psi (298 kPa, 3.0 kg/cm2 ) Or More | |||
| Overhaul | SPECIFICATION | |||
| Torque | See Torque Specifications in Text or applicable graphics under COMPONENT | |||
| Fluid Specifications | See FLUIDS under MAINTENANCE tab. From within Manager or Service Writer, click the "30/60/90 Interval" or "Maint." button. | |||
| Flywheel/Flex Plate (Drive Plate) Torque | 22.1 Ft. lb. (30 N.m) Plus Additional 30-35 Degrees |
|||
| Fuel System | ||||
| Fuel Pressure Test Procedure | FUEL PRESSURE | |||
| Fuel Pressure Specification | 50-66 psi (350-450 kPa, 3.5 - 4.6 kgf/cm2 ) | |||
| Fuel Filter Location | Attached to fuel pump unit. | |||
| Fuel Filter R & I | ||||
| Except Hybrid | FUEL FILTER | |||
| Ignition | ||||
| Firing Order & Cylinder Identification | FIRING ORDER & CYLINDER IDENTIFICATION | |||
| Ignition Wires (Resistance) | Engine has coil-on-plug ignition. | |||
| Ignition Wires (Routing) | Engine has coil-on-plug ignition. | |||
| Spark Plug | NGK: DILKAR7B8/ Gap: 0.7-0.8 mm (0.028-0.031 in.)/ Tightening Torque: 18 N.m (13.3 ft-lb) | |||
| Starting | ||||
| Starter | ||||
| Except Hybrid | SPECIFICATION | |||
| Torque | 37 Ft. lb. (50 N.m) | |||
| Wheel Alignment | ||||
| Adjustment Specifications | ||||
| Front | WHEEL ALIGNMENT | |||
| Rear | WHEEL ALIGNMENT | |||
| Torque | ||||
| Front | See Torque Specifications in text under COMPONENTS WITH TORQUE SPECIFICATIONS | |||
| Rear | See Torque Specifications in text under COMPONENTS WITH TORQUE SPECIFICATIONS | |||
| Wheel & Tire | ||||
| Wheel Lug Nut Torque | 88.5 Ft. lb. (120 N.m) | |||