LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2018 >> Crosstrek Base, Standard Trans >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Anti-Theft System - Security And Locks >> Key Lock Cylinders >> Replacement >> Front Door

Front Door

  1. Raise the glass assembly - front door to the top position.
  2. Remove the cover - handle front outer.
    1. Remove the plug at the rear end of the panel assembly - front door.
      G11246295Courtesy of SUBARU OF AMERICA, INC.
    2. Loosen the TORX® bolt and remove the cover - handle front outer.

      Preparation tool: 

      TORX® T30

      G11246296Courtesy of SUBARU OF AMERICA, INC.
    3. Replace the key cylinder.
      1. Release the claws.
      2. Remove the key cylinder (b) from the cover - handle front outer (a), and replace the key cylinder.
        G11246363Courtesy of SUBARU OF AMERICA, INC.
    4. Install the cover - handle front outer.
      CAUTION:
      • When installing the cover - handle front outer on driver's side, make sure that the key cylinder shaft is correctly inserted into the latch & actuator assembly - front.
      • After installation, perform the operation check using the key.

      Preparation tool: 

      TORX® T30

      Tightening torque: 

      7.5N.m (0.8kgf-m, 5.5ft-lb)

scientia non olet · About LEMON Manuals