Auxiliary Emission Control Systems: Canister: Installation
- INSTALL CHARCOAL CANISTER ASSEMBLY
- Install the canister bracket B to the charcoal canister assembly with 2 nuts. Standard value: T=8.0N.m {82kgf.cm} {5.9ft.lbf}
- Install the charcoal canister assembly with canister bracket B with the 2 bolts and the nut. Standard value: Bolt
T=7.5N.m {76kgf.cm} {5.5ft.lbf}
Nut
T=8.0N.m {82kgf.cm} {5.9ft.lbf}
- Connect the fuel tank vent tube as indicated by the arrows, in the order shown in the illustration.
- Connect the purge tube as shown in the illustration.
- INSTALL CANISTER PUMP MODULE
- Install the drain tube C.
- Connect the drain tube A and the drain tube B.
- Engage the clamp.
- Install the nuts and bracket B.
Standard value: T= 18N.m {184kgf.cm} {13.3ft.lbf}
- Install the 2 nuts and bracket A.
Standard value: T= 18N.m {184kgf.cm} {13.3ft.lbf}
- Engage the clip.
- Install the canister pump module with 3 bolts.
Standard value: T=7.5N.m {77kgf.cm} {5.5ft.lbf}
- Connect the evaporation hose to the fuel pipe assembly.
- Engage the clip.
- Connect the drain tube A to the fuel filler pipe.
- Connect the drain tube B to the charcoal canister assembly.
- Refer to REAR SUSPENSION MEMBER SUB-ASSEMBLY INSTALLATION .
- Refer to REAR DIFFERENTIAL CARRIER ASSEMBLY INSTALLATION .