Rear Axle Hub: Installation
NOTE:
- The following procedure is for LH side.
- Perform the same procedures for the RH and LH side.
- Installation of rear axle hub and bearing ASSY LH
- Install the rear axle hub and bearing ASSY LH to the rear axle carrier with 4 bolts.
Standard value: T=65N.m {663kgf.cm} {47.9ft.lbf}
- Install the rear axle hub and bearing ASSY LH to the rear axle carrier with 4 bolts.
- Installation of rear disc (Refer to INSTALLATION (BREMBO TYPE) )
- Installation of rear drive shaft ASSY (Refer to INSTALLATION )
- Connection of rear disc brake caliper ASSY LH (Refer to ASSEMBLY )
- Installation of rear axle shaft nut LHCAUTION:
- Always clean the drive shaft even if it is new.
- Clean and remove oil, foreign matter, etc. completely.
- Install a new rear axle shaft nut LH using a socket wrench.
Standard value: T=190N.m {1938kgf.cm} {140.1ft.lbf}
CAUTION: Do not crimp the rear axle shaft nut LH.NOTE: After the inspection of the rear axle hub and bearing ASSY LH play and runout, crimp the rear axle shaft nut LH.
- Inspection of rear axle hub & bearing ASSY axial play (Refer to ON-VEHICLE INSPECTION )
- Inspection of rear axle hub & bearing ASSY runout (Refer to ON-VEHICLE INSPECTION
)
- Securing of rear axle shaft nut LH
- Crimp the rear axle shaft nut LH using a chisel and a hammer.
- Installation of speed sensor RR LH
- Install the speed sensor RR LH with a bolt.
Standard value: T=7.5N.m {77kgf.cm} {5.5ft.lbf}
CAUTION: Keep the tip and mounting portion of the speed sensor RR LH free from foreign matter.
- Install the speed sensor RR LH with a bolt.
- Installation of rear tire
Standard value: T=120N.m {1224kgf.cm} {88.5ft.lbf}
- Adjustment of parking brake lever free play (Refer to PARKING BRAKE SYSTEM )
- Inspection of test mode (speed sensor check) (Refer to WORK SUPPORT )