DTC P0336 Crankshaft Position Sensor "A" Circuit Range/Performance: Notes

DTC DETECTING CONDITION: 

Detected when two consecutive driving cycles with fault occur.

TROUBLE SYMPTOM: 

• Engine stalls.
• Failure of engine to start
  CAUTION: After servicing or replacing faulty parts, perform Clear Memory Mode <Ref. to OPERATION , Clear Memory Mode.>, and Inspection Mode <Ref. to PROCEDURE , Inspection Mode.>.

Step	Check	Yes	No
1 CHECK CONDITION OF CRANKSHAFT POSITION SENSOR.  Turn the ignition switch to OFF.	Is the crankshaft position sensor installation bolt tightened securely?	Go to step 2  .	Tighten the crankshaft position sensor installation bolt securely. <Ref. to Crankshaft Position Sensor .>
2 CHECK CRANK SPROCKET.  Remove the timing belt cover.	Are crank sprocket teeth cracked or damaged?	Replace the crank sprocket. <Ref. to Crank Sprocket .>	Go to step 3  .
3 CHECK INSTALLATION CONDITION OF TIMING BELT.  Turn the crankshaft, and align alignment mark on crank sprocket with alignment mark on cylinder block. ST 499987500 CRANKSHAFT SOCKET	Is the timing belt dislocated from its proper position?	Repair the installation condition of timing belt. <Ref. to Timing Belt .>	Replace the crankshaft position sensor. <Ref. to Crankshaft Position Sensor .>