LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2017 >> WRX STI >> Repair and Diagnosis (Single Page) >> Engine Performance >> System >> Engine Control System (Diagnostics) (P000A To P015B) (2.5L) >> Diagnostic Procedure with Diagnostic Trouble Code (DTC) >> DTC P0113 Intake Air Temperature Sensor 1 Circuit High Bank 1 >> Notes

DTC P0113 Intake Air Temperature Sensor 1 Circuit High Bank 1: Notes

DTC DETECTING CONDITION: 

Immediately at fault recognition

TROUBLE SYMPTOM: 

CAUTION: After servicing or replacing faulty parts, perform Clear Memory Mode <Ref. to OPERATION , Clear Memory Mode.>, and Inspection Mode <Ref. to PROCEDURE , Inspection Mode.>.

WIRING DIAGRAM: 

Engine Electrical System <Ref. to WIRING DIAGRAM , Engine Electrical System.>

Fig 1: Mass/Volume Air Flow Sensor A Circuit Low Wiring Diagram
G11574226Courtesy of SUBARU OF AMERICA, INC.
Step Check Yes No
1 CHECK CURRENT DATA. 
  1. Start the engine.
  2. Read the value of «Intake Air Temp.» using the Subaru Select Monitor or a general scan tool.
    NOTE:
    • Subaru Select Monitor

      For detailed operation procedures, refer to "Current Data Display For Engine". <Ref. to Subaru Select Monitor .>

    • General scan tool

    For detailed operation procedures, refer to the general scan tool operation manual.

 Is the value of «Intake Air Temp.» less than -40°C (-40°F)? Go to step 2.  Even if DTC is detected, the circuit has returned to a normal condition at this time. Reproduce the failure, and then perform the diagnosis again.
NOTE: In this case, temporary poor contact of connector, temporary open or short circuit of harness may be the cause.
2 CHECK FOR POOR CONTACT. 
Check for poor contact of ECM and mass air flow and intake air temperature sensor connector.		 Is there poor contact of ECM or mass air flow and intake air temperature sensor connector? Repair the poor contact of ECM or mass air flow and intake air temperature sensor connector. Go to step 3. 
3 CHECK HARNESS BETWEEN ECM AND MASS AIR FLOW AND INTAKE AIR TEMPERATURE SENSOR CONNECTOR. 
  1. Turn the ignition switch to OFF.
  2. Disconnect the connector from ECM.
  3. Disconnect the connectors from the mass air flow and intake air temperature sensor.
  4. Measure the resistance of harness between ECM connector and the mass air flow and intake air temperature sensor connector.

    Connector & terminal 

    (B136) No. 31 - (B3) No. 1: 

    (B135) No. 30 - (B3) No. 2: 

 Is the resistance less than 1 Ω? Go to step 4.  Repair the harness and connector.
NOTE: In this case, repair the following item:
  • Open circuit in harness between ECM connector and the mass air flow and intake air temperature sensor connector
  • Poor contact of joint connector
4 CHECK HARNESS BETWEEN ECM AND MASS AIR FLOW AND INTAKE AIR TEMPERATURE SENSOR CONNECTOR. 
  1. Connect all connectors.
  2. Turn the ignition switch to ON.
  3. Measure the voltage between ECM connector and chassis ground.

    Connector & terminal 

    (B136) No. 31 (+) - Chassis ground (-): 

 Is the voltage 5 V or more? Repair the short circuit of harness to power supply between ECM connector and the mass air flow and intake air temperature sensor connector. Replace the mass air flow and intake air temperature sensor. <Ref. to Mass Air Flow and Intake Air Temperature Sensor .>
scientia non olet · About LEMON Manuals