Oil Leaking From AVCS Oil Control Valve (02-170-17R)
Publication date: 2019-04-23Reference number: 02-170-17R
Supersedes refnos: 02-170-17
OIL LEAKING FROM AVCS OIL CONTROL VALVE
SERVICE CAMPAIGN BULLETIN
| SUBARU: | 2013-19 BRZ; 2015-19 WRX; 2014-18 Forester Turbo; 2013-19 Legacy and Outback; 2012-19 Impreza; 2013-19 Crosstrek; 2011-19 Forester |
APPLICABILITY
2013-19MY BRZ
2015-19MY WRX
2014-18MY Forester Turbo
(Models Equipped with FA Engines)
2013-19MY Legacy and Outback
2012-19MY Impreza
2013-19MY Crosstrek
2011-19MY Forester
(Models Equipped with FB Engines)
INTRODUCTION
This bulletin announces part information for new Active Valve Control System (AVCS) oil control solenoid valves (OCV) which contain a redesigned internal oil seal. The new seal will eliminate potential oil see page into the wire harness connector portion of the valve. If oil seeps into the connector, over time, the Check Engine lamp may illuminate and set various AVCS-related DTCs.
Subaru Service Bulletins are intended for use by professional technicians ONLY They are written to inform those technicians of conditions that may occur in some vehicles, or to provide information that could assist in the proper servicing of the vehicle. Properly trained technicians have the equipment, tools, safety instructions, and know-how to do the job correctly and safely. If a condition is described, DO NOT assume that this Service Bulletin applies to your vehicle, or that your vehicle will have that condition.
SUBARU OF AMERICA, INC. IS ISO 14001 COMPLIANT
ISO 14001 is the international standard for excellence in Environmental Management Systems. Please recycle or dispose of automotive products in a manner that is friendly to our environment and in accordance with all local, state and federal laws and regulations.
PRODUCTION CHANGE INFORMATION
The new OCVs were incorporated into production starting with the following VINs.
| Vehicle/Model | Starting VIN |
|---|---|
| Legacy | J3221066 |
| Outback | J3009467 |
| Impreza | J3601119 |
| Crosstrek | J3702623 |
| Forester | JH425420 |
| WRX | J9807386 |
| BRZ | H9604945 |
PART INFORMATION
| Description | NEW Part Number | OLD Part Number |
|---|---|---|
| VALVE ASSEMBLY-OIL CONTROL | 10921AA231 | 10921AA230 |
| 10921AA241 | 10921AA240 | |
| 10921AA23B | 10921AA23A |
New OCVs can be identified by their production lot number located on the face of the solenoid as shown in the illustration below.
SERVICE PROCEDURE/INFORMATION
If oil is found in the harness connector during diagnosis of AVCS-related DTCs, replace the affected OCV with a new part as listed in the parts information supplied above. Follow the service procedures as outlined in the applicable Service Manual.
There have been a small number of reports involving engine oil "wicking" past the OCV engine harness connector and into the related wiring harnesses and connectors as shown in the photos below.
If related engine wiring harnesses and/or connectors are contaminated, the harness itself may also need to be replaced if degreasing affected components using a spray parts cleaner is unsuccessful.
WARRANTY/CLAIM INFORMATION
For vehicles within the Basic New Car Limited or covered by an active Subaru Added Security Gold plan, please consult the Labor Time Guide for applicable claim coding information.
IMPORTANT REMINDERS:
- SOA strongly discourages the printing and/or local storage of service information as previously released information and electronic publications may be updated at any time.
- Always check for any open recalls or campaigns anytime a vehicle is in for servicing.
- Always refer to STIS for the latest service information before performing any repairs.