Check Shift Indicator
WARNING: This page is about a different variant/trim than selected.
DIAGNOSIS:
- CAN communication is abnormal with the combination meter.
- Combination meter malfunction
TROUBLE SYMPTOM:
- Shift indicator does not display or remains displayed.
- Shift indicator display does not change.
| Step | Check | Yes | No |
|---|---|---|---|
| 1 CHECK DTC. Read the DTC relating the TCM using the Subaru Select Monitor. |
Is DTC U0155 or U0423 displayed? | Perform the self-diagnosis of combination meter. | Go to step 2 . |
| 2 CHECK DTC. Read the DTC relating the TCM using the Subaru Select Monitor. |
Are DTCs other than U0155 and U0423 displayed? | Perform the diagnosis according to DTC. | Go to step 3 . |
| 3 CHECK COMBINATION METER. Read DTC of combination meter. |
Is DTC displayed? | Perform the diagnosis according to DTC. | Go to step 4 . |
4 CHECK TCM.
|
Does it change between ON and OFF according to the operation? | Go to step 5. | Check for poor contact between TCM and paddle shift UP switch, and repair the defective part. |
5 CHECK TCM.
|
Does it change between ON and OFF according to the operation? | Go to step 6. | Check for poor contact between TCM and paddle shift down switch, and repair the defective part. |
6 CHECK TCM.
|
Is "1" displayed? | Go to step 7. | Perform the diagnosis according to DTC P0951. <Ref. to DTC P0951 AUTO SHIFT MANUAL CONTROL CIRCUIT RANGE/PERFORMANCE , Diagnostic Procedure with Diagnostic Trouble Code (DTC).> |
7 CHECK TCM.
|
Is "2" displayed? | Current condition is normal. | Replace the TCM. <Ref. to Transmission Control Module (TCM) .> |