LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2017 >> WRX Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 17 (Continuously Variable Transaxle (CVT) (Service Information)) >> Secondary Pressure Sensor >> Removal

Secondary Pressure Sensor: Removal

WARNING: This page is about a different variant/trim than selected.
CAUTION:
  • Be sure to prevent water or oil from contacting the connector terminal of secondary pressure sensor. If adhesion occurs, replace with a new part.
  • When removing secondary pressure sensor, CVTF may let out. If CVTF has leaked, adjust the CVTF level after installing the secondary pressure sensor.
  1. Disconnect the ground terminal from battery sensor. <Ref. to BATTERY , NOTE, Note.>
  2. Lift up the vehicle.
  3. Clean the transmission exterior.
  4. Remove the secondary pressure sensor harness connector.
  5. Remove the secondary pressure sensor.
    NOTE: Use Ko-ken 3/8 12-point 27 mm (manufacturer product No. 3305M-27) deep socket.
    Fig 1: Removing Secondary Pressure Sensor
    G09482013Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals