LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2017 >> WRX Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 17 (Continuously Variable Transaxle (CVT) (Service Information)) >> General Description >> Preparation Tool >> General Tool

General Tool

WARNING: This page is about a different variant/trim than selected.
TOOL NAME REMARKS
Circuit tester Used for measuring resistance, voltage and current.
Thickness gauge Used for the clearance in reverse brake, forward clutch, transfer clutch and input clutch.
Caliper Used for measuring the clearance at the parts.
Spring scale Used for measuring the starting torque of the drive pinion.
TORX® bit T70 Used for removing and installing differential gear oil drain plug.
Straight pin remover Used for removing and installing the spring pin.
Deep socket Used for removing and installing the secondary pressure sensor.
NOTE: Use Ko-ken 3/8 12-point 27 mm (manufacturer product No. 3305M-27).
Push/pull gauge Used for measuring clutch clearance.
Angle gauge
  • Used for installing the hypoid driven gear.
  • Used for installing the drive plate.
DST-i Used together with Subaru Select Monitor 4.
scientia non olet · About LEMON Manuals