Diagnostic Mode

The settings of the multi-function display can be changed by performing the following procedures to display the diagnostic mode. To show the demonstration display only, refer to "DEMONSTRATION DISPLAY".

CAUTION:

To avoid battery discharge, perform the procedure while charging the battery.
While performing the work, close the front hood and all doors, and do not operate any electrical parts.
Display can not be switched to diagnostic mode if the illumination control dial is set to the position for the dimming cancel function (maximum brightness).

Procedure

CAUTION: Perform the steps described in (2) through (4) within 10 seconds.

(1)	Within 3 seconds after turning the ignition switch to ON, set the lighting switch to the parking light or headlight position.
(2)	While holding the lighting switch to the parking light or headlight position, press the MFD (ENTER) switch three times.
(3)	Turn the lighting switch to OFF, and press the MFD (ENTER) switch three times.
(4)	Set the lighting switch to the parking light or headlight position again, and press the MFD (ENTER) switch three times.
(5)	Go to "Diagnostic mode".

NOTE:

Except for the demonstration display setting of the diagnostic mode, the display will terminate by turning the ignition switch to OFF (ACC OFF) or by selecting "Back" from the menu screen.
The demonstration display setting of the diagnostic mode will terminate by starting the engine or removing the battery. Even if the ignition switch is turned to OFF (ACC OFF), then to ON again, the diagnostic mode will not terminate.
To select other menus from the demonstration display setting, terminate the diagnostic mode by starting the engine or removing the battery, then access to the diagnostic mode again.

Display menu

Change the display and settings from each menu.

Item

Content

Demonstration display setting

Shows demonstration display.

Vehicle status confirmation

CAN communication

Displays the connection status of input signals.

U-ART communication

Camera connection

Customize

Key operation sound

Select "ON" or "OFF", then select "Set" to determine.

Correction of lifetime fuel economy value⁽¹⁾

Adjust the fuel economy value within the range of -10 - +10 km/l, then determine the value with MFD (ENTER) switch.

Back

Finish the diagnostic mode.

⁽¹⁾	Correction of lifetime fuel economy value is used only when the multi-function display has been replaced. This function is provided as a compensation feature to bring the current lifetime fuel economy value to the one before the replacement of multi-function display.