Parking Brake Cable: Installation

CAUTION:

After installing the backrest assembly, make sure that each seat belt operates normally.
Make sure that they are properly secured on each hook on the vehicle side.

Install the cable assembly - parking brake.
Tightening torque:

Cable clamp: 18 N.m (1.8 kgf-m, 13.3 ft-lb)
Install the cable assembly - parking brake to the lever section of parking brake shoe. <Ref. to INSTALLATION , Parking Brake Assembly (Rear Disc Brake).>
Install the grommet to the rear floor.
Install the propeller shaft assembly. <Ref. to INSTALLATION , Propeller Shaft.>
Install the exhaust pipe and muffler.
- Center exhaust pipe & rear exhaust pipe: <Ref. to INSTALLATION , Rear Exhaust Pipe.>
- Muffler: <Ref. to INSTALLATION , Muffler.>
Install the fuel tank protector.
- Except for STI model <Ref. to INSTALLATION , Fuel Tank Protector.>
- STI model <Ref. to INSTALLATION , Fuel Tank Protector.>
Place the floor mat to the original position, and then attach the clip and the knob of the hook - seat cushion rear.
Install the side sill covers - rear INN on the right and left side.
Install the rear seat cushion assembly.
Install the inner cable end to equalizer, and install the clamp A - hand brake cable.
Install the lever assembly - hand brake.
Tightening torque:

18 N.m (1.8 kgf-m, 13.3 ft-lb)
Install the console box assembly.
Install the rear wheels.
Tightening torque:

120 N.m (12.2 kgf-m, 88.5 ft-lb)
Connect the battery ground terminal. <Ref. to BATTERY , NOTE, Note.>

NOTE: For CVT models, after connecting the battery sensor terminal, place the select lever in the P position.