Front Hood: Installation

NOTE: When the hood COMPL - front is replaced, adhere the label on the same position.

Temporarily fit the hinge COMPL - front hood around the original position on the vehicle body.
Install the hood COMPL - front to the hinge COMPL - front hood.
Tightening torque:

25 N.m (2.5 kgf-m, 18.4 ft-lb)
Install the stay assembly - front hood.
When temporarily fitting the fender COMPL - front and adjusting the clearance, make sure that a uniform clearance is created around the hood COMPL - front.
NOTE: When installing the fender COMPL - front, make sure that a uniform clearance is created around it.
- Fender COMPL - front to Hood COMPL - front: <Ref. to ADJUSTMENT , Front Hood.>
- Fender COMPL - front to Panel assembly - front door: <Ref. to ADJUSTMENT , Front Door.>
Install the hinge COMPL - front hood.
1. Tighten the bolts at the front side, and temporarily fit the bolts at the rear side.
2. Remove the fender COMPL - front, and tighten to the specified torque.
Tightening torque:

25 N.m (2.5 kgf-m, 18.4 ft-lb)
Readjust the fender COMPL - front to install.

NOTE: When installing the fender COMPL - front, make sure that a uniform clearance is created around it.

Fender COMPL - front to Hood COMPL - front: <Ref. to ADJUSTMENT , Front Hood.>
Fender COMPL - front to Panel assembly - front door: <Ref. to ADJUSTMENT , Front Door.>