DTC U0482 Invalid Data Received From Headlamp Leveling Control Module

DTC DETECTING CONDITION:

Invalid data was transmitted from auto headlight beam leveler Control Module.

TROUBLE SYMPTOM:

The auto headlight beam leveler does not operate normally.

Step	Check	Yes	No
1 CHECK CAN COMMUNICATION HARNESS. Perform the basic diagnostic procedure to check for fault in CAN communication harness. <Ref. to BASIC DIAGNOSTIC PROCEDURE .>	Was the basic diagnostic procedure performed up to step 7?	Go to step 2 .	Perform the basic diagnostic procedure. <Ref. to BASIC DIAGNOSTIC PROCEDURE .>
2 CHECK DTC (OTHER THAN U-CODE). Check the displayed DTC.	Are DTCs other than U*** displayed?	Perform the diagnosis for DTCs other than the displayed U-code.	Go to step 3 .
3 CHECK DTC (U-CODE). Check the displayed DTC.	Is DTC for the bus off or the data no-receive displayed?	Perform the diagnosis for DTCs for the displayed bus off or the data no-receive.	Go to step 4 .
4 CHECK DTC (CURRENT MALFUNCTION). Check the displayed DTC.	Is U0482 a current malfunction?	Go to step 5 .	Go to step 7 .
5 CHECK DTC (CURRENT MALFUNCTION). Turn the ignition switch to OFF. Disconnect the auto headlight beam leveler Control Module connector. Connect the disconnected connectors. Read the DTC using Subaru Select Monitor. <Ref. to READ DIAGNOSTIC TROUBLE CODE (DTC) .>	Is U0482 a current malfunction?	Go to step 6 .	Go to step 7 .
6 CHECK DTC. Using the Subaru Select Monitor, read DTC of all the systems. <Ref. to READ DIAGNOSTIC TROUBLE CODE (DTC) .>	Is the MFD invalid data detected in several modules?	Replace the auto headlight beam leveler Control Module. <Ref. to Auto Headlight Beam Leveler Control Module .>	Replace the module that the DTC has been detected.
7 CHECK HARNESS. Shake the harness, and check for poor contact. Using the Subaru Select Monitor, read DTC of CAN system. <Ref. to READ DIAGNOSTIC TROUBLE CODE (DTC) .>	Is U0482 a current malfunction?	Repair the poor contact of harness, or replace the harness.	Go to step 8 .
8 CHECK CONNECTOR. Check the connector used for high speed CAN for poor contact.	Is there poor contact of connector?	Repair the connector that has poor contact, or replace harness.	It is possible that temporary poor communication occurs. Delete the DTC.