LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2017 >> WRX Base >> Repair and Diagnosis (Single Page) >> Engine Performance >> System >> Engine Control System (Diagnostics) (P000A To P015B) (2.0L) >> Diagnostic Procedure with Diagnostic Trouble Code (DTC) >> DTC P0068 Map/MAF - Throttle Position Correlation >> Notes

DTC P0068 Map/MAF - Throttle Position Correlation: Notes

DTC DETECTING CONDITION: 

Detected when two consecutive driving cycles with fault occur.

CAUTION: After servicing or replacing faulty parts, perform Clear Memory Mode <Ref. to OPERATION , Clear Memory Mode.>, and Inspection Mode <Ref. to PROCEDURE , Inspection Mode.>.
Step Check Yes No
1 CHECK AIR INTAKE SYSTEM.  Are there holes, loose bolts or disconnection of hose on air intake system? Repair the air intake system. Go to step .
2 CHECK MANIFOLD ABSOLUTE PRESSURE AND INTAKE AIR TEMPERATURE SENSOR. 
  1. Start the engine and warm up engine until coolant temperature is higher than 75°C (167°F).
  2. For CVT models, set the select lever to "P" range or "N" range, and for MT models, place the shift lever in the neutral position.
  3. Turn the A/C switch to OFF.
  4. Turn all the accessory switches to OFF.
  5. Using the Subaru Select Monitor or a general scan tool, read the value in «Mani. Absolute Pressure».
NOTE:
  • Subaru Select Monitor

For detailed operation procedures, refer to "Read Current Data For Engine". <Ref. to Subaru Select Monitor .>
  • General scan tool

For detailed operation procedures, refer to the general scan tool operation manual.
Is the value in «Mani. Absolute Pressure» 73.3 - 106.6 kPa (550 - 800 mmHg, 21.65 - 31.50 inHg) when the ignition is turned ON, and 20.0 - 46.7 kPa (150 - 350 mmHg, 5.91 - 13.78 inHg) during idling? Go to step . Replace the manifold absolute pressure and intake air temperature sensor. <Ref. to Manifold Absolute Pressure and Intake Air Temperature Sensor .>
3 CHECK THROTTLE OPENING ANGLE. 
Using the Subaru Select Monitor or a general scan tool, read the value in «Throttle Opening Angle».
NOTE:
  • Subaru Select Monitor

For detailed operation procedures, refer to "Read Current Data For Engine". <Ref. to Subaru Select Monitor .>
  • General scan tool

For detailed operation procedures, refer to the general scan tool operation manual.
Is the value in «Throttle Opening Angle» with the throttle fully closed less than 5%? Go to step . Replace the electronic throttle control. <Ref. to Throttle Body .>
4 CHECK THROTTLE OPENING ANGLE.  Is the value in «Throttle Opening Angle» with the throttle fully open 85% or more? Replace the manifold absolute pressure and intake air temperature sensor. <Ref. to Manifold Absolute Pressure and Intake Air Temperature Sensor .> Replace the electronic throttle control. <Ref. to Throttle Body .>