Registration Body Integrated Unit (Function Setting)

CAUTION: For the body integrated unit, function selection is available to control the entire vehicle systems. It is possible to control the original functions of vehicle when registrations of body integrated unit and function setting are corresponded to vehicle equipment.
If registrations and function setting are different from vehicle equipment, vehicle system does not operate normally and diagnosis cannot be performed correctly. Pay attention to following item.

Be sure to correspond registrations, or User Customizing settings to vehicle equipment.
Do not change the settings of vehicle improperly.
Make sure that the key illumination does not blink with ignition switch ON, or that the body integrated unit registration item "Factory initial setting" is set to "Market". If "Factory initial setting" is set to "Factory", key illumination blinks when the ignition switch is turned ON, to notify that the settings are not confirmed. (If the vehicle is a model with the keyless access with push button start system, check by the current data display function of Subaru Select Monitor because no key illumination is available.)
Key illumination does not blink with ignition switch turned to ON and go off with door closed. (Except for model with the keyless access with push button start system)
Be sure to register immobilizer if body integrated unit is replaced with a new part. (Except for model with the keyless access with push button start system)
Make a registration of immobilizer when the parts related to immobilizer have been replaced. Refer to the "REGISTRATION MANUAL FOR IMMOBILIZER" provided as a separate volume.

On «Start» display, select «Diagnosis».
On «Vehicle selection» display, input the target vehicle information and select «Confirmed».
On «Main Menu» display, select «Each System».
On «Select System» display, select «Body Control» and then select «Enter».
On «Select Function» display, select «Customize».
NOTE: For the vehicle requiring the destination setting, if the destination setting is not finished, display can not be shifted into customizing screen. <Ref. to DESTINATION SETTING , OPERATION, Registration Body Integrated Unit.>
Change the setting to the contents saved at confirmation of current setting.
CAUTION:
- To perform normal operation of vehicle and diagnosis, the above settings must match the actual vehicle equipment.
- When the body integrated unit is new or in Factory mode, the key illumination blinks, and user customizing is incomplete. Check the user customizing settings. (For models with keyless access with push button start system, the room light illuminates.)
- Be sure not to change Factory initial setting except when installing a new body integrated unit.
NOTE: "Factory" mode:
- Body integrated unit has not been set yet. It can be recognized by key illumination blinking with ignition switch turned to ON. (Except for model with the keyless access with push button start system)
- All replacement body integrated units are set to "Factory" mode. When replacing a body integrated unit, be sure to perform the registration operation.
  "Market" mode:
- Each settings have been set. It can be recognized by key ring illumination coming on in concocting with room light and going off with ignition switch turned to ON. (Except for model with the keyless access with push button start system)
Perform the factory initial setting. Select «Factory initial setting» in the «Customize» screen of the Subaru Select Monitor.
Change the mode from Factory to Market.
Turn the ignition switch to OFF to settle the setting.
Perform the User Customizing. <Ref. to OPERATION , User Customizing.>
Change the system selection to «Immobilizer» on Subaru Select Monitor, and perform registration of immobilizer. (Models without the keyless access with push button start system)
Follow the procedure of the "REGISTRATION MANUAL FOR IMMOBILIZER" provided as a separate volume.
When key registration is completed, "Do you want to register remote engine start?" is displayed. Perform registration only for equipped models. (Displayed only on models without the keyless access with push button start system)

NOTE: For detailed operation procedures, refer to "Application help".