Front Suspension: General Description: Caution

When performing any work, always wear work clothes, a work cap and protective shoes. Additionally, wear a helmet, protective goggles, etc. if necessary.
When disposing of strut COMPL - front, be sure to bleed the oil or gas out completely. Also, do not expose to flames or fire.
When performing a repair, identify the cause of trouble and avoid unnecessary removal, disassembly and replacement.
Use SUBARU genuine grease, the recommended or equivalent. Do not mix grease etc. of different grades or manufacturers.
Do not secure a part in a vise directly. Place cushioning materials such as wood pieces, blocks, aluminum plates, or waste cloth between the part and the vise.
Be sure to tighten fasteners including bolts and nuts to the specified torque.
Always use the jack-up point when the shop jacks or rigid racks are used to support the vehicle.
When the suspension-related components have been removed, installed or replaced, perform the following adjustment.
- Lane keep assist learning value clear (model with EyeSight): Ref. to OPERATION , Clear Active Lane Keep System Learning Value.
- VDC sensor midpoint setting mode: Ref. to ADJUSTMENT , VDC Control Module and Hydraulic Control Unit (VDCCM & H/U).
For parts which are not reusable, always use new parts. Other parts should be replaced with new parts as required.
When handling oil or fuel, adhere to the following to prevent unexpected accident.
- Be careful with fire.
- Prepare a container to catch grease or oil, etc. If any grease or oil spills, wipe it off and clean immediately to prevent from penetrating into floor or flowing outside.
- Follow all government and local regulations concerning disposal of refuse when disposing.
Be sure that the surface of brake disc or brake pad is free from grease or oil.
Before disconnecting connectors of sensors or units, be sure to disconnect the ground cable from battery.
Some vehicle components are extremely hot immediately after driving. Be wary of receiving burns from heated parts.