Trunk Opener Switch: Inspection

Measure the resistance between connector terminals.

Preparation tool:

Circuit tester

Fig 1: Door Lock Actuator Connector Terminals

Courtesy of SUBARU OF AMERICA, INC.

Terminal No.	Inspection conditions	Standard
1 - 4	Switch OFF	1 MΩ or more
1 - 4	Switch ON	Less than 1 Ω

Apply battery voltage between the connector terminals to check lighting condition of illumination inside the switch.

Terminal No.	Inspection conditions	Specification
2 (+) - 3 (-)	Apply battery voltage.	Light ON

If the inspection result is not within the standard, replace the switch - trunk opener.