DTC P0011: "A" Camshaft Position - Timing Over-Advanced Or System Performance Bank 1: Notes
DTC detecting condition:
Detected when two consecutive driving cycles with fault occur.
Trouble symptom:
- Engine stalls.
- Improper idling
CAUTION:
After servicing or replacing faulty parts, perform Clear Memory Mode Ref. to
OPERATION
, Clear Memory Mode, and Inspection Mode Ref. to
PROCEDURE
, Inspection Mode.
| Step | Check | Yes | No |
|---|---|---|---|
1 IDENTIFYING FAULTY PART.
|
Did the detected DTC shift to the location where the oil control solenoid was replaced? | Replace the faulty oil control solenoid. | Go to step 2 |
2 CHECK CURRENT DATA.
NOTE:
For detailed operation procedures, refer to "Current Data Display For Engine". Ref. to
SUBARU SELECT MONITOR
|
Is the value of «VVT Adv. Ang. Amount R» approx. 0 deg? | Go to step 3 | Check the following item and repair or replace if necessary.
|
3 CHECK CURRENT DATA.
NOTE:
For detailed operation procedures, refer to "Current Data Display For Engine". Ref. to
SUBARU SELECT MONITOR
|
When the value of «OCV Duty R» increases more than 10%, is the value of «VVT Adv. Ang. Amount R» approx. 0 deg? | Check the following item and repair or replace if necessary.
|
Perform the following procedures, and clean the oil routing. Replace the engine oil and idle the engine for 5 minutes, and then replace the oil filter and engine oil. Ref. to REPLACEMENT , Engine Oil. Ref. to ENGINE OIL FILTER |