LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2017 >> Outback 2.5i >> Repair and Diagnosis (Single Page) >> Body & Frame >> Seats >> Seat System - Seats >> Power Seat System >> Installation >> Power Seat Control Module (Seat With Memory Function)

Power Seat Control Module (Seat With Memory Function)

  1. Install the power seat control module.

    Tightening torque: 

    5.9 N.m (0.6 kgf-m, 4.4 ft-lb) 

  2. Install the seat assembly. Ref. to INSTALLATION , Front Seat.
  3. Raise the seat cushion by operating the switch.
  4. Install the seat assembly. Ref. to INSTALLATION , Front Seat.
    NOTE:
    • The seat with memory function must be initialized after installed. Ref. to ADJUSTMENT , Power Seat System.
    • After replacing a seat with memory function and the power seat control module, check the following items.
    1. Memory is reloaded by pressing the seat memory switch, when the ignition is ON and the select lever is set to the "P" range.
    2. Memory is not reloaded even if the seat memory switch is pressed, when the ignition is ON and the select lever is set to other than "P" range.
    3. Memory is reloaded when the ignition is OFF and the seat memory switch located inside the driver's door is pressed within 45 seconds after the door is opened.
    4. Memory is reloaded automatically when the ignition is OFF and the driver's door is opened after unlocked by access key. (Model with smart key interlock function)
scientia non olet · About LEMON Manuals