Unable To Set Positions Into Memory (Driver's Seat With Memory Function)

Step	Check	Yes	No
1 CHECK POWER SEAT CONTROL MODULE. Turn the ignition switch to ON. Display «Set SW» «Memory SW1» «Memory SW2» on «Data monitor» of the power seat control module using Subaru Select Monitor. NOTE: For detailed operation procedures, refer to "Application help". Perform the inspection after an item is selected in the data select display.	Does the display change corresponding to the switch operation?	Go to step 5 .	Go to step 2 .
2 CHECK SWITCH. Disconnect the memory switch connector. Check memory switch. Ref. to CHECK MEMORY SWITCH (DRIVER'S SEAT WITH MEMORY FUNCTION) , INSPECTION, Power Seat System.	Is the inspection result normal?	Go to step 3 .	Replace the memory switch assembly.
3 CHECK HARNESS. Disconnect the power seat control module connector. Measure the resistance between the memory switch connector and power seat control module connector. Connector & terminal (R155) No. 13 - (D143) No. 3: (R155) No. 14 - (D143) No. 2: (R155) No. 29 - (D143) No. 8:	Is the resistance less than 10 Ω?	Go to step 4 .	Check power seat harness.
4 CHECK GROUND CIRCUIT. Measure the resistance between the memory switch connector and chassis ground. Connector & terminal (R143) No. 1 - Chassis ground:	Is the resistance less than 10 Ω?	Go to step 5 .	Check body harness.
5 SYSTEM INITIALIZATION. Initialize memory seat system. Ref. to ADJUSTMENT , Power Seat System.	Is the initialization completed successfully?	Replace the power seat control module.	Ref. to UNABLE TO PERFORM INITIALIZATION (DRIVER'S SEAT WITH MEMORY FUNCTION) , INSPECTION, Power Seat System.