Steering Wheel: Installation
CAUTION:
- Before handling the airbag system components, refer to "CAUTION" of "General Description" in "AIRBAG SYSTEM". Ref. to CAUTION , General Description.
- If the steering wheel and steering angle sensor are removed, perform the following VDC setting mode. Ref. to VDC SENSOR MIDPOINT SETTING MODE (MODELS WITHOUT EyeSight) , ADJUSTMENT, VDC Control Module and Hydraulic Control Unit (VDCCM & H/U).
- Model without EyeSight: VDC sensor midpoint setting mode Ref. to VDC SENSOR MIDPOINT SETTING MODE (MODELS WITHOUT EyeSight) , ADJUSTMENT, VDC Control Module and Hydraulic Control Unit (VDCCM & H/U).
- Model with EyeSight: Neutral of Steering Angle Sensor & Lateral G Sensor 0 point setting Ref. to NEUTRAL OF STEERING ANGLE SENSOR & LATERAL G SENSOR 0 POINT SETTING (MODEL WITH EyeSight) , ADJUSTMENT, VDC Control Module and Hydraulic Control Unit (VDCCM & H/U).
- Model with EyeSight: Longitudinal G sensor & lateral G sensor 0 point setting Ref. to LONGITUDINAL G SENSOR & LATERAL G SENSOR 0 POINT SETTING MODE (MODEL WITH EyeSight) , ADJUSTMENT, VDC Control Module and Hydraulic Control Unit (VDCCM & H/U).
- Align the center position of the roll connector. Ref. to ADJUSTMENT , Roll Connector.
- Install each part in the reverse order of removal.
NOTE:
Align the alignment marks on the steering wheel and the column assembly - steering.
Tightening torque:
Steering wheel: 39 N.m (3.98 kgf-m, 28.8 ft-lb)
Clearance:
Between cover assembly - column and steering wheel: 4 - 6 mm (0.16 - 0.24 in)