LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2017 >> Crosstrek Base >> Repair and Diagnosis (Single Page) >> Electrical >> Gauges >> Instrumentation System & Driver Information Center >> Multi-function Display (MFD) >> Inspection >> Multi-Function Display Switch

Multi-Function Display Switch

  1. Measure the resistance between connector terminals.

    Preparation tool: 

    Circuit tester 

    Fig 1: Multi-Function Display Switch Circuit Diagram
    G10270903Courtesy of SUBARU OF AMERICA, INC.
    Terminal No Inspection conditions Standard
    2 - 3 Δ (UP)
    ENTER
    (DOWN)    		 All OFF 1 MΩ or more
    Δ (UP) ON Less than 1 Ω
    ENTER ON Approx. 1, 000 Ω
    (DOWN) ON Approx. 3, 670 Ω
  2. Apply battery voltage between the connector terminals to check lighting condition of illumination inside the switch.
    Terminal No. Inspection conditions Specification
    4 (+) - 1 (-) Apply battery voltage. Light ON
  3. If the inspection result is not within the standard, replace the switch - multi-function display.
scientia non olet · About LEMON Manuals